Wheel Bearing Unit, Removing And Installing, AWD: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
-- Remove the brake rotor. Refer to FRONT BRAKE ROTOR, REMOVING AND INSTALLING or REAR BRAKE ROTOR, REMOVING AND INSTALLING .
-- Remove the expanding rivets -2-.
-- Pull the wind deflector -1- slightly outward in the direction of the -arrow- and remove.
-- Remove the bolts -arrows- in stages, and remove the wheel bearing unit from the drive axle and the wheel bearing housing at the same time.
- Handling the wheel bearing. Refer to Figure.