LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Rear Suspension) >> 42 Rear Suspension >> Control Arm, Tie Rod >> Upper Transverse Link, Removing And Installing >> Rear Upper Transverse Link, Removing And Installing >> Removing

Rear Upper Transverse Link, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

-- Before starting the procedure, determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

-- FWD equipment version: Lower the subframe and do not remove the brake caliper and shock absorber while doing so. Refer to SUBFRAME, REMOVING AND INSTALLING .

-- AWD equipment version: Remove the subframe. Refer to SUBFRAME, REMOVING AND INSTALLING .

-- Disconnect the threaded connection -3-.

GWWA42-10829Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and remove the upper transverse link -2-.