Lower Transverse Link
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Wind Deflector
- Equipped on some models
- Bolt
- Replace after removing.
- Front Lower Transverse Link
- Removing and installing. Refer to FRONT LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Installation position. Refer to Figure.
- Wind Deflector
- Eccentric Bolt
- Subframe
- Nut
- 40 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Nut
- 140 Nm
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Loosen and tighten using the 21 mm internal multi-point socket
- Eccentric Washer
- Rear Lower Transverse Link
- Removing and installing. Refer to REAR LOWER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Expanding Rivet
- Bolt
- Replace after removing
- Wheel Bearing Housing
- Nut
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .