Steering Column, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Bring the steering column into the installation position by engaging the mounting hooks -1- on the central tube -2- -arrow-.
Equipment Versions with Anti-Theft Protection Component
-- Bring the bolt -2- with the anti-theft protection component lower section -1- into the installation position.
-- Tighten the bolts. Refer to Figure.
-- Drive the anti-theft protection component upper section -3- flush into the lower section using a plastic mallet.
-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
-- Install the knee airbag. Refer to KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
- Calibrate the Steering Angle Sensor -G85-. Refer to Steering Angle Sensor -G85- BASIC SETTING .