Wheel Bearing Housing, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Slide the wheel bearing housing onto the drive axle splines.
-- Install the control arm. Refer to CONTROL ARM, REMOVING AND INSTALLING .
-- Install the upper control arm. Refer to UPPER CONTROL ARM, REMOVING AND INSTALLING .
-- Tighten the threaded connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .