LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Front Suspension) >> 40 Front Suspension >> SUBFRAME >> Stabilizer Bar, Removing And Installing >> Installing

Stabilizer Bar, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

There must be no grease on the stabilizer bar and rubber bushing.

If a stud bolt for the clamp has loosened, tighten it all the way.

-- Install the threaded connections for the stabilizer bar only until the stop, but do not tighten yet.

NOTE:

Bonded rubber bushings have a limited range of rotation. Only tighten the threaded connections for the suspension when the vehicle is in curb weight position.

-- Lift the wheel bearing in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

scientia non olet · About LEMON Manuals