SUBFRAME CROSSBRACE, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Engine and Gearbox Jack: VAS6931
- Rear Axle Support: T10552
- Puller - Ball Joint: T40043
- Strut: T40335
- Locating Pin: T40334
- Mount: T40386 , not illustrated
Tools, Preparing
-- Loosen the bolts -arrows-.
-- Adjust the dimension -a-.
- Dimension -a- = 250 mm
-- Tighten the bolts again.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe Crossbrace to Subframe
- Bolts - Subframe Crossbrace/Steering Gear to Subframe
- Bolt - Clip to Subframe Crossbrace