Overview - SUBFRAME: Subframe
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 90 Nm +90°
- Always replace after removing
- Fitting Bolt
- 90 Nm +90°
- Always replace after removing
- Bolt
- 30 Nm
- Subframe Crossbrace
- Removing and installing. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
- Bolt
- Subframe
- Securing. Refer to SUBFRAME, SECURING .
- Lowering. Refer to SUBFRAME, LOWERING .
- Removing and installing. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .
- Bolts
- 9 Nm
- Shield
- Removing and installing. Refer to SUBFRAME SHIELD, REMOVING AND INSTALLING .
- Nut
- 9 Nm
- Steering Gear
- Overview. Refer to OVERVIEW - STEERING GEAR .
- Bolt
- Bolt
- Clip
Subframe Crossbrace, All Except A5 Cabriolet, Tightening Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Sequence |
|---|---|---|
| 1. | -arrows- | Install by hand all the way |
| 2. | -arrows- | Tighten diagonally in stages |
| 3. | Remove the : T40334 | |
| 4. | -1 and 2- | Tighten |
Subframe Crossbrace, A5 Cabriolet, Tightening Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Sequence |
|---|---|---|
| 1. | -arrows- | Install by hand all the way |
| 2. | -arrows- | Tighten diagonally in stages |
| 3. | Remove the : T40334 | |
| 4. | -1 and 2- | Tighten |