Stabilizer Bar
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 30 Nm
- Always replace after removing
- Remove and tighten evenly alternating from side to side.
- Clamp
- Stabilizer Bar
- With rubber bushing
- The rubber bushing cannot be replaced separately
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Nut
- 40 Nm + 90°
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Subframe
- Bolt
- Always replace after removing
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Shock Absorber Fork
- Removing and installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
- Nut
- 40 Nm + 90°
- Always replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Bolt
- Always replace after removing