Belt Pulley Side Sealing Flange, Removing And Installing, 3.0L Engine: Removing
WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING, 3.0L ENGINE .
-- Remove the air duct pipe. Refer to UPPER AIR DUCT PIPE, REMOVING AND INSTALLING, 3.0L ENGINE .
-- Disconnect the connector -3- and remove the Cylinder Head Coolant Valve -N489- from the bracket -2-.
-- Disconnect the connector -1-.
-- Remove the bolts -arrows- and tie up the bracket to the side.
All additional procedures are described. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .