Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, 2.9L ENGINE
WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Removal - Vehicles with Version 1 Charge Air System:
-- Loosen the hose clamps -1 and 3- and remove the air duct hose.
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Removal - Vehicles with Version 2 Charge Air System:
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor -G31-.
Installing
Install in reverse order of removal and note the following:
- Check the O-ring for damage. Refer to OVERVIEW - CHARGE AIR SYSTEM .
Tightening Specifications
- Refer to OVERVIEW - CHARGE AIR SYSTEM
- Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .