Overview - Coolant Pump/Coolant Thermostat
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
(shown on 3.0L engine).
- Coolant Shut-Off Valve
- Removing and installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Bolt
- 10 Nm + 90°
- Always replace after removing.
- Belt Pulley
- For the coolant pump
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Always replace after removing.
- Seal
- Replace the Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Always replace after removing.
- O-Ring
- Always replace after removing.
- Seal
- Always replace after removing.
- Bolt
- 9 Nm
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | 9 Nm |
| 2. | -1 to 7- | 9 Nm |