Overview - Belt Pulley Side Sealing Flange
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Seal
- For the belt pulley side crankshaft
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Sealing Flange, Belt Pulley Side
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Alignment Sleeve
- Bolt
- 9 Nm
- Oil Dipstick Tube
- Seals
- Always replace after removing.
- Alignment Sleeve
- O-Ring
- Always replace after removing.
Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 17- | 3 Nm |
| 2. | -1 to 17- | 90° additional turn |