Crankshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Unit Injector: T10055
- Torx Screw Driver - T25: T10248
- Locking Pin (3 pc.): T40011
- Puller: T40332
- Pull Rod: T40332/1
- Cross Bar: T40332/2
- Threaded Pins: T40332/3
- Adjusting Pin: T40362
Puller : T40332 , Preparing
-- Tighten the pull rod -1- with the bolts -arrows- as shown on the puller cross bar : T40332 .
-- Remove the threaded pins -2- for later assembly of the tool.