Roller Bearing, Replacing: Removing
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Engine secured on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the crankshaft. Refer to OVERVIEW - CRANKSHAFT .
-- Remove the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
-- Position the correct side of the special tool on the roller bearing.
- The bevel -arrow- faces the roller bearing.
-- Align the Adapter: T40395/3 .
- The side without the bevel -arrows- faces down.
-- Remove the front roller bearing -1- and rear roller bearing -2- inward using the Spindle: T40395/1 , Adapter: T40395/2 and Adapter: T40395/3 by turning the Nut: T40395/4 .
-- Remove the special tool and then the roller bearing.