Roller Bearing, Replacing: Installing
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Position the correct side of the adapter on the roller bearing.
- The bevel -arrow- faces toward the roller bearing and specifies the installation depth.
-- Align the Adapter: T40395/3 .
- The side without the bevel -arrows- faces down.
-- Install the front roller bearing -1- and the rear roller bearing -2- in all the way using the Spindle: T40395/1 , Adapter: T40395/2 and Adapter: T40395/3 by turning the Nut: T40395/4 .
- The labeled sides of the roller bearing face toward the outside.
-- Install the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
-- Install the crankshaft. Refer to OVERVIEW - CRANKSHAFT .