Overview - Balance Shaft
WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 40 Nm + 45°
- Always replace after removing.
- Gear
- With the chain sprocket for the camshaft timing chain
- Bolt
- 9 Nm
- Balance Shaft
- Removing and installing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
- Roller Bearing
- Replacing. Refer to ROLLER BEARING, REPLACING .
- Balance Weight
- Can only be placed on the balance shaft in one position
- Bolt
- 40 Nm + 90°
- Always replace after removing.
- Roller Bearing
- Replacing. Refer to ROLLER BEARING, REPLACING .
- Thrust Washer
- Seal
- Always replace after removing.
- Gear Carrier