Lower Timing Chain Cover, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is removed. Refer to the appropriate Service Information .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the upper timing chain covers. Refer to TIMING CHAIN GUARD UPPER SECTION, REMOVING AND INSTALLING .

-- Disconnect the connector -2- for the Engine Speed Sensor -G28-.

Fig 1: After-Run Coolant Pump -V51-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and -1 to 6-.

Fig 2: Lower Timing Chain Cover

Courtesy of AUDI OF AMERICA, LLC

-- To loosen the lower timing chain cover -1-, install the three M6x20 bolts -arrows- until the stop.

Courtesy of AUDI OF AMERICA, LLC

-- Install each bolt ¹ /₂ turn, until the lower timing chain cover has loosened.

-- Remove the bolts again, remove the lower timing chain cover and remove the transmission side crankshaft seal.