Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2022 Audi S5, 2021 Audi S5, 2020 Audi S5, and 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety precautions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Cabriolet:

-- Remove the right rear side trim panel. Refer to OVERVIEW - SIDE TRIM PANEL .

-- If installed, remove the Right Rear Subwoofer -R240-. Refer to COMPONENT LOCATION OVERVIEW - SOUND SYSTEM .

All:

-- Remove the bench seat / single seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Release the catches -arrows- using a screwdriver and remove the Fuel Pump Control Module -J538- -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel pump control module from under the sill panel/side trim panel.

-- Release the connector safety catch and disconnect the connector -2- for the Fuel Pump Control Module -J538-.