Small Right Rear Coolant Pipe, Removing And Installing, 3.0L Engine: Installing

WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the O-ring after removing.
Used coolant cannot be used again.

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING, 3.0L ENGINE .