LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Lubrication [CWGD,DECA,CZSE,DLZA,DKMB,CZSA,DCBD,DCBE]) >> 17 Lubrication >> Oil Pan/Oil Pump >> Oil Pan Lower Section, Removing And Installing >> Removing

Oil Pan Lower Section, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- If installed, remove the bolt -1- and move the bracket -2- and wiring harness to the side.

Fig 1: Identifying Wiring Harness Bracket
GWWA17-11000Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- on the Oil Level Thermal Sensor -G266-.

Fig 2: Oil Pan Lower Section - Tightening Sequence
GWWA17-11066Courtesy of AUDI OF AMERICA, LLC

-- Free up the wires.

-- Loosen and remove the bolts in the following sequence: -17 to 1-.

-- Loosen and remove the oil pan lower section carefully from the bonding.