Overview - Coolant Pump/Coolant Thermostat
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
(shown on 3.0L engine).
- Coolant Shut-Off Valve
- Removing and installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Bolt
- 10 Nm + 90°
- Always replace after removing.
- Belt Pulley
- For the coolant pump
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Always replace after removing.
- Seal
- Replace the Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Always replace after removing.
- O-Ring
- Always replace after removing.
- Seal
- Always replace after removing.
- Bolt
- 9 Nm
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | 9 Nm |
| 2. | -1 to 7- | 9 Nm |