Crankshaft Seal, Replacing, Transmission Side

Special tools and workshop equipment required 

• Crankshaft Seal Installer Kit :T10122B 
• Puller - Crankshaft/Power Steering Seal :T20143/2 

Procedure 

• The transmission is removed. Refer to the appropriate service information .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the sensor wheel. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .

-- Pry out the seal using the :T20143/2  .

Fig 1: Prying Out Crankshaft Seal Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

-- Clean the contact and sealing surface.

Fig 2: Guide Piece T10122/6 And Push Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Place the :T10122/1  on the :T10122/6  and seal -A- with the closed side on the guide piece.

-- Remove the :T10122/1  .

-- Position the :T10122/6  on the crankshaft.

Fig 3: Identifying Seal Installer - Crankshaft - Guide Piece T10122/6

Courtesy of AUDI OF AMERICA, LLC

-- Using the bolts -arrows- from the :T10122/6  attach via the mounting point -A- on the crankshaft.

-- Push the seal on the crankshaft by hand using the : T10122/6  .

-- Press the seal in evenly all around using the :T10122/5  .

Fig 4: Install Shaft Seal In Evenly All Around With Thrust Piece T10122/5 Until Flush

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :T10122/6  .

-- Check the seal as well as its sealing lip for correct seating. If the sealing lip is partially rolled back, repeat the procedure with a new seal.

-- Install the sensor wheel. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .