Ribbed Belt For Starter Generator, Removing And Installing, 3.0L Engine: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the ribbed belt. Refer to Figure.
-- Pivot the ribbed belt tensioner for the generator using a wrench slightly counter-clockwise -arrow- and remove the :T40098 .
-- To tension the ribbed belt release the tensioner.
-- Check whether the ribbed belt is routed correctly.
-- Start the engine and check the ribbed belt routing.
There are different procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .