Crankshaft, Measuring Radial Clearance
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Plastigauge®
Procedure
- Use the old bolts for radial clearance measurement.
-- Remove the bearing cap and clean the bearing journals.
-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.
- The Plastigauge® must rest in the center of the bearing shell.
-- Position the bearing cap and tighten it an additional turn; do not turn the crankshaft. Refer to Figure.
-- Reinstall the bearing cap.
-- Compare the width of the Plastigauge® with the measuring scale.
Radial clearance:
- New: 0.021 to 0.036 mm.
- Wear limit: 0.08 mm.
-- Replace the bolts for the final assembly.