Camshaft Timing Chain, Removing From Camshafts, Cylinder Bank 2 (Left): Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm :VAG1331
- Electronic Torque Wrench 3-60Nm :VAS6583
- Locking Pins :T03006
- Crankshaft Locking Pin :T40069 (with the engine removed)
- Wrench - 21mm :T40263
- Camshaft Lock :T40264/3
- Adapter :T40314
- Camshaft locking device :T40331
- Camshaft Positioning Tool :T40331/1
- Camshaft Positioning Tool :T40331/5
- :T40331/6
- Bolts :T40331/9
- Socket E24 :T90000
- Counter holder :T90001
- Counterholder :T90002
- Torque Wrench Insert - Ring Tool Attachment AF41 :VAS261001
NOTE:
For the following procedure the camshaft timing chain remains on the engine.
:T40331 , Preparing
- The lettering "B" on the :T40331/1 points forward.
- The :T40331/5 and :T40331/6 as well as the washers on the : T40331/9 must be positioned using the alignment pins -arrows-.
-- Tighten the bolts hand-tight.