Transmission Mount, Removing And Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Support, Removing with Transmission Mount

-- Remove the tunnel crossmember. Refer to the appropriate service information .

-- Remove the bolts -arrows- and remove the transmission support -1- with the transmission mount from the transmission.

Courtesy of AUDI OF AMERICA, LLC

Transmission Mount, Removing and Installing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and remove the stop -2- for the transmission mount.

-- Remove the nut -5- and remove the transmission mount -3- from the transmission support -4-. (The transmission support does not correspond to the version in the vehicle.)

Installing

Install in reverse order of removal and note the following:

-- Tighten the nut -5- hand-tight.

-- Tighten the bolts -1- and then the nut -5-.

-- Install the transmission support with the transmission mount.

Tightening Specifications

Refer to the appropriate service information .