Engine, Securing To Engine And Transmission Holder
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S5, 2022 Audi RS 5 Sportback, 2022 Audi RS 5, 2021 Audi S5, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine and Gearbox Bracket VAS6095A :VAS6095A
- Engine/Transmission Holder - Universal Mounting :VAS6095/1 and V6 TFSI Engine Bracket :VAS6095/1-15
Procedure
-- Remove the bolts -arrows- and remove the left engine support.
If the Chain Drive on the Connection Should Be Worked On:
-- Remove the vacuum hose -2- at the same time to not damage it.
-- Free up the wiring harness -3-.
-- Remove the nuts -4- and bolt -5-.
-- Remove the vacuum reservoir -1-.
-- Remove the plug -1- for "TDC" hole and remove the bracket -2-.
Continuation:
-- Remove the ground cable nut -arrow-.
-- Remove the bolts -arrows- and remove the right engine support -1-.
-- Remove the starter. Refer to STARTER, REMOVING AND INSTALLING .
-- Secure the engine to the :VAS6095 using the :VAS6095/1-15 and :VAS6095/1-11 and tighten to 40 Nm.