Overview - Charge Air System, 3.0L Engine-Side, Version 1: Notes

WARNING: This page is about a different car, the 2022 Audi S5, 2022 Audi RS 5, 2021 Audi S5, 2021 Audi RS 5, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Charge Air System, 3.0L Engine-Side, Version 1

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Tightening Specifications and Sequence. Refer to Figure.
Upper Air Guide Pipe
- Removing and installing. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .
Bolt
- Tightening Specifications and Sequence. Refer to Figure.
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
Bolt
- 5 Nm
Bolt
- 8 Nm
- For model versions
Connection
- Model versions
Seal
- Replace after removing.
- For model versions
Air Duct Pipe
- There are different versions. Refer to the Parts Information for the allocation.
Bolt
- 9 Nm
Seal
- Replace after removing.
Intake Manifold with Crankcase Ventilation Hose
- Removing and Installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- The crankcase ventilation hose cannot be separated from the intake manifold. Note the information:
  - Crankcase Ventilation Hose on Intake Manifold, Rest of World Vehicles. Refer to Crankcase Ventilation Hose on Intake Manifold, Rest of World Vehicles .
  - Crankcase Ventilation Hose on Intake Manifold, USA Vehicles. Refer to Crankcase Ventilation Hose on Intake Manifold, USA Vehicles .
Bolt
- 9 Nm
Seal
- Replace after removing.
Turbocharger
- Overview. Refer to OVERVIEW - TURBOCHARGER, 3.0L ENGINE .
Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-
- Removing and Installing. Refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
O-Ring
- Not available separately; replace if leaking -item 15- or damaged
Throttle Valve Control Module -GX3-
- Removing and installing. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING
- Cleaning. Refer to Throttle Valve Control Module -GX3-, CLEANING .
Seal
- Replace after removing.
Connection
Bolt
- Step 1: 5 Nm
- Step 2: 6 Nm
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
Seal
- Replace after removing.
Intake Manifold
- Overview. Refer to OVERVIEW - INTAKE MANIFOLD .
Seal
- Replace after removing.
Bolt
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Tightening Specifications and Sequence. Refer to Figure.