Coolant Pump Toothed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the bolts that were tightened with an additional turn after removing them.
Note the toothed belt sprocket installation location -item 12-.

-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

-- If removed, install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .