LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2022 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Turbocharger, Supercharger [CYMC,CYRB,CYRC,CWPB,DDWA,DKNA,DKWA,DLHB,DDWB]) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air System, Checking For Leaks

Charge Air System, Checking For Leaks

WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

Procedure 

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and the air guide -2-.

GWWA23-11009Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -arrows-.

GWWA21-10921Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2- and air duct pipe -1-.

-- Install the : VAG1687/6  and : VAG1687/13-2  on the turbocharger.

GWWA21-11088Courtesy of AUDI OF AMERICA, LLC
GWWA26-11726Courtesy of AUDI OF AMERICA, LLC

-- Loosen the threaded connections -arrows- and slide the clamping sleeves toward the rear.

GWWA10-11905Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk of damaging the coupling due to improper handling.

- Coupling must not be bent more than 10°.

- Do not load the coupling on the cable.

-- Slightly lower the front muffler -2- and secure as shown with a cable tie -1-.

-- Seal the front muffler with the : VAG1687/3  and : VAG1687/15  .

GWWA21-11085Courtesy of AUDI OF AMERICA, LLC

-- Connect the : VAG1687  with the connection -5- on the : VAG1687/6  .

GWWN26-11343Courtesy of AUDI OF AMERICA, LLC

Refer to CHARGE AIR SYSTEM, CHECKING FOR LEAKS .

Assembling 

Assemble in the reverse order of removal. Note the following:

-- Install the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specifications