2020 A5 / S5

WARNING: This page is about a different car, the 2020 Audi S5 and 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Audi Pre-Delivery Inspection


_{Stock Number}	_{Dealer Number}	_{R.O. Number}

_VIN	_{Road Test Mileage Out}	_{Road Test Mileage In}

Reminders

→ All items must be completed prior to customer delivery by a certified Audi technician

→ Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection

→ ALL PDI function tests must be run in Guided Fault Finding (GFF) using PDI Total Function Test Plan only. Do NOT use Guided Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS Diagnosis for using GFF for PDI function tests

→ It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF

→ For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information

→ For items marked with **, follow instructions for stock inventory vehicle

√ all completed items
Vehicle Preparation
□	Check Elsa for open campaigns and updates
□	Verify Audi Phone Box Customer Registration form is present in car and fill out "Serial Number" field. Check Elsa "Vehicle Information" Section or location sticker on car. See TSB 2051720
□	Perform any open campaigns*
□	Perform diagnostic work*
Exterior
□	Check all key buttons and features*
□	Inspect exterior for damage, dings, dents and surface scratches. Report and repair any damage before delivery to the customer
Lighting and Windshield
□	Test exterior lighting functions
□	Test windshield washers. Correct aim if necessary*
Trunk Inspection
□	Verify trunk is operational
□	Verify operation of emergency release handle
□	Install wheel bolt cover removal tool from PDI kit into trunk tool kit*
□	Verify tool kit is installed securely in luggage compartment
□	Set spare tire pressure*
□	Check battery clamps for proper torque*
Interior
□	Verify operation of all seat belts and latches
□	Check operation of window, lock, and seat controls*
□	Inspect mirrors for proper operation*
□	Check rear view mirror operation*
□	Verify operation of all interior lights
□	Verify SOS button is green and Roadside assistance button LED will remain off. Reference TSB 2052299 if issues occur
□	Verify operation of heated seats
□	Verify operation of rear heated seats (if equipped)
□	Verify operation of ventilated seats (if equipped)
□	Verify proper operation of climate control*
□	Inspect operation of all power outlets*
□	Check panoramic sunroof and sunshade operation*
□	Verify the glove compartment opens and closes properly
□	Verify operation of front Passenger Occupant Detection System
Settings
□	Verify operation of MMI® touch (if equipped)
□	Set time source setting to "GPS" (if equipped) and set auto daylight savings time to "on" *
□	Set Time to "Automatic setting" and "Automatic time zone"
□	Verify and set language and measurement units*
□	Verify Speech Dialog System is operating
□	Set "Entertain. Fad." in parking aid to an audible level*
□	Set "Music volume while parking" to medium*
□	Set dealership location in navigation (if equipped)*
□	Turn off Manual Speed Warning* (if equipped)*
Media / Radio / SAT
□	Verify operation of aux. input
□	Insert SD card and test function of slots
□	Verify HD Radio_TM is turned "off"*
Audi connect® (USA ONLY) (if equipped)
□	Turn on the Wi-Fi® hotspot (if equipped)*
□	Check Wi-Fi® hotspot visibility. No data available at PDI (if equipped)*
□	Enable Google Earth view for navigation (if equipped)*
On-Hoist Inspection
□	Remove transport suspension blocks (follow ELSA instruction)
□	Check steering, boots, brake system, hoses, tires and wheels for damage
□	Check underside of vehicle for fluid leaks and loose components
□	Inspect wheel bolts for proper torque*
□	Install wheel locks (if equipped)
□	Install wheel bolt covers and center caps as supplied*
□	Set and store tire pressures for either sold vehicle OR stock inventory vehicle*
Driving Performance
□	Check horn operation
□	Verify hold and release of electronic parking brake
□	Verify engine Start-Stop System functionality*
□	Verify engine performance and acceleration*
□	Verify transmission operation, including shift paddles
□	Test drive vehicle applying brakes several times*
□	Check steering / tire alignment
□	Check for squeaks, rattles and wind noise. Repair any squeaks, rattles or wind noises before delivery to the customer
□	Calibrate rear view mirror*
□	Verify quality of radio reception in AM / FM / SiriusXM® bands
Driver Assistance
□	Verify cruise control / ACC with Stop & Go functionality (if equipped)
□	Verify Audi side assist functionality (if equipped)
□	Verify Audi active lane assist functionality (if equipped)
□	Verify operation of parking system (if equipped)*
□	Verify all vehicle Head-up display functionality (if equipped)*
□	Activate not available and follow directions back to dealership (if equipped)
Convertible Functionality (if equipped)
□	Test operation of power folding top*
□	Verify convertible top manual closing tools are present
Post-Road Test Inspection
□	Interrogate fault memory and upload diagnostic log to GFF Paperless Server
□	Check service interval and verify correct interval is displayed
□	Check engine oil level*
□	Check all fluid levels and top off if necessary
□	Ensure the yellow tire pressure tag is installed on the steering wheel
□	Apply 30 Day Inventory Maintenance Sticker**
□	Install showroom charger to ensure battery remains charged at all times**

Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery.


_{Technician Signature}	_{Last 8 of VIN}	_{Completion Date}

_{Effective 8-22-2019-US Version 1.0}