Lower Timing Chain Cover, Replacing: Removing

WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Engine oil drained. Refer to ENGINE OIL .

-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Free up the wires.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 and 2- and pivot the left coolant pipe upward.

-- Unclip the oil dipstick tube -1- on the upper timing chain cover in direction of -arrow- and remove from the lower timing chain cover.

Courtesy of AUDI OF AMERICA, LLC

-- Vehicles with generator: remove the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Remove the bolts -1 through 15-.

Fig 1: 15 Bolts Timing Chain Cover Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE:

There may be only eight bolts installed, depending on the version.

-- Loosen the lower timing chain cover from the bonding.