Bearing Bracket, Removing And Installing: Installing

WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the bolts -arrows- and tighten them. Tightening specifications -item 4-.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Coat the holes -arrows- with engine oil.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the adapter sleeve -1- is installed.

If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.

Fig 2: Bearing Bracket - Assembly Instructions
Courtesy of AUDI OF AMERICA, LLC
If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Bolt. Refer to the Parts Information.

Carefully connect the bearing bracket without tilting - risk of damage.

Fig 3: Identifying Bolts
Courtesy of AUDI OF AMERICA, LLC

-- Attach the bearing mount and install the bolts -arrows- all the way by hand.

-- Remove the :T40267 .

-- Tighten the bearing bracket bolts. Refer to Figure.

Installation is performed in reverse order of removal, noting the following:

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .