New Connecting Rod, Separating
WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
New connecting rods might not be completely separated at the predetermined breaking point. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:
-- Mark the cylinder where the connecting rod is allocated to -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Connecting Rod.
-- Lightly clamp the connecting rod -1- in a vise equipped with aluminum protective pads.
- Clamp the connecting rod lightly to prevent damaging it.
- Clamp the connecting rod below the dotted line.
-- Loosen both bolts -2- approximately five turns.
-- Carefully tap the connecting rod bearing cap -1- with a plastic hammer in direction of -arrow- until it comes loose.