Overview - Balance Shaft

Fig 1: Exploded View Of Balance Shaft

Courtesy of AUDI OF AMERICA, LLC

1. Cylinder Block
2. Bolt
   • 9 Nm
3. Intake Side Balance Shaft
   • Replace in pairs only. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
   • Lubricate the bearing with engine oil
4. Pipe
   • Installation position. Refer to  10.
   • For the exhaust side balance shaft
   • 136 mm in length
5. Bolt
   • 9 Nm
6. Exhaust Side Balance Shaft
   • Replace in pairs only. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
   • Lubricate the bearing with engine oil
7. Needle Bearing
   • Replace after removing
   • The needle bearing rim is colored, a needle bearing of the same color must be installed.
   • Lubricate the bearing with engine oil
   • To install, tightly press together the needle cage until it engages.
8. Needle Bearing
   • Replace after removing
   • The needle bearing rim is colored, a needle bearing of the same color must be installed.
   • Lubricate the bearing with engine oil
   • To install, tightly press together the needle cage until it engages.
9. Pipe
   • For the intake side balance shaft
   • 123 mm in length
   • Installation position. Refer to the figure below.
10. Seal
    • Replacing. Refer to BALANCE SHAFT GASKET, REPLACING, INTAKE SIDE .
    • For the intake side balance shaft

Balance Shaft Pipe Installation Position

Courtesy of AUDI OF AMERICA, LLC

• The tab -arrow A- on the balance shaft must engage in the cut-out -arrow B- on the pipe.