Terminal 30 Wire Junction 3 -TV28-, REMOVING AND INSTALLING: Removing

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, Disconnecting And Connecting, 0K2 .

-- Release the retainers in direction of -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine control module -3- and with the lines -1- attached move to the side.

-- Free up the wiring harness -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -3 and 4- and the bolts -1-.

-- Remove the engine control module mount -2-.

-- Release the latch in direction of -arrow- and open the cover -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wires -6 and 7- and free them up.

-- Remove the nut -5- and free up the wire -3-.

-- Remove the nuts -2 and 8-.

-- Remove the wire junction -4-.