Relay and Fuse Panel 4 -SR4-, REMOVING AND INSTALLING: Removing
-- Remove the right front sill panel. Refer to Overview - Sill Panel .
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery, Disconnecting And Connecting .
-- Push the carpet in the area of the footwell to the side as far as possible.
-- Release the catch -5- and open the cover -4- in direction of -arrow-.
-- Remove the nuts -1, 2 and 3- and free up the wires.
-- Remove the relay -2- from the mount -1- by opening the clip in direction of -arrow-.
-- Release the retainer in direction of -arrow- and remove the wire junction -1-.
-- Release the clips in direction of -arrows- and press the relay panel -2- back and out of the bracket -1-.