Data Bus On Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, CABRIOLET: Removing

-- Remove the rear seat backrest. Refer to Backrest Heating Element, Removing And Installing .

-- Remove the expanding clips -3- using the Pliers:T40172C  .

Courtesy of AUDI OF AMERICA, LLC

-- Lift the front luggage compartment floor -1- in the data bus on board diagnostic interface area.

-- Disconnect the connectors -6- and antenna wires -2-.

-- Release the retainers in direction of -arrows-.

-- Remove the data bus on board diagnostic interface -4- from the mount -5-.