Brake Fluid Reservoir, Removing And Installing: Installing

• Coat the plugs on the brake fluid reservoir with brake fluid.

-- Insert the brake fluid reservoir into the plugs in the brake master cylinder.

Further installation is performed in reverse order of removal, while noting the following:

-- Fill the brake fluid reservoir up to the "MIN" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to Hydraulic System, Bleeding .

-- Install the plenum chamber cover. Refer to Plenum Chamber Bulkhead, Removing And Installing .

-- Check brake fluid level, and fill if necessary.