Backrest Release Trim, Removing And Installing
Special tools and workshop equipment required
- Trim Removal Wedge :3409
Removing, Standard/Sport Seat
-- Pull the operating lever -2- upward and hold it pressed.
-- Push a flat-head screwdriver between the trim -1- and operating lever, as shown.
-- Release the right catches in direction of -arrow A-.
-- Repeat the procedure on the opposite side left hook -arrow B-.
-- Bring the operating lever -1- back into the resting position.
-- Pull the trim -2- by hand over the operating lever -arrow- and disengage, if necessary push on the opposite side.
-- If installed, disconnect the connector for the entry assistance switch.
Removing, Super Sport Seat
-- Unclip the trim -1- for the backrest release starting at the top using the :3409 -arrow-.
-- Remove the trim upward, guide out the pull strap and remove.
Installing
-- Pull the operating lever slightly upward, guide the trim over the operating lever and engage the rear tabs in the backrest release.
Further installation is the reverse order of removal.