Bumper Cover, Adjusting

Depending on the equipment version, the following additional work must be performed. Refer to Depending on the version, the following additional work is required below.

Procedure

-- Loosen bolts -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the front bumper cover lengthwise according to the markings -arrow-.

-- Tighten the bolts.

-- Check the gap dimension for evenness, and repeat the adjustment if necessary.

Depending on the version, the following additional work is required:

-- Adjust the adaptive cruise control. Refer to Adaptive Cruise Control (ACC) .

Note the conditions here for a required adjustment of the adaptive cruise control (ACC).

-- Calibrate the Front Peripheral Camera -R243-. Refer to PERIPHERAL CAMERA, CALIBRATING .

Note the conditions here for a required calibration of the Front Peripheral Camera -R243-.

Tightening Specifications