Clutch End Cover, Removing And Installing: Installing
- Replacing clutch end cover and circlip.
-- Thoroughly grease the contact surface for the seal from the clutch end cover -arrow-.
-- Clean the contact surfaces for the outer seals of the clutch end cover.
Risk of leaks on the clutch end cover.
Transmission damage due to oil loss.
- Do not touch the seal in the inner opening of the clutch end cover!
- Do not load the clutch end cover by hitting with a hammer.
-- Only handle the clutch end cover as shown -in this illustration- !
- Do not apply any stickers to inside of the clutch end cover. If there is a sticker carefully remove it.
-- Grease the : T10459 before using and clean, do not use scratched sleeves.
-- Place the : T10459 on a level surface.
-- Guide the clutch end cover horizontally and evenly over the whole : T10459 . This brings the sealing lip into its installation position.
-- Remove the : T10459 upward out of the cover and place it on the end of the clutch shaft.
-- Coat the outer cover seal with oil.
Risk of leaks on the clutch end cover.
Transmission damage due to oil loss.
- Do not touch the seal in the inner opening of the clutch end cover!
- Do not load the clutch end cover by hitting with a hammer.
-- Guide the cover horizontally over the : T10459 and press it evenly onto its seat.
It is possible to carefully pry the cover into its place using a -screwdriver-, until the >>new<< circlip can be installed.
-- Install the new circlip.
-- Remove the : T10459 only after the circlip is installed.
-- Install the transmission. Refer to TRANSMISSION, INSTALLING .
-- Fill with transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING
-- After installing the transmission, perform the basic setting using the Guided Functions using the Vehicle Diagnostic Tester.