Overview - Seat Position Sensor

NOTE:

The seat position sensor with wiring harness for the front passenger seat is illustrated for the TT Coupe.

Fig 1: Exploded View Of Seat Position Sensor

Courtesy of AUDI OF AMERICA, LLC

Connector Coupling
- Connector station in the vehicle floor under on the side sill under the seat.
Bolt
- 1.2 Nm
Front Passenger Occupant Detection Sensor -G128-
- Only the front passenger side
- Removing and installing. Refer to Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
Passenger Occupant Detection Sensor Bracket
- Clipped in the seat frame.
- Removing and installing. Refer to Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
Wiring Harness
- Clipped in the seat frame.
Connector Coupling
- For the belt latch
Seat Rail
- Tunnel-side
Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Checking. Refer to Vehicle Diagnostic Tester.
Bolt
- 1.2 Nm
Connector Coupling
- Only for the front passenger seat: for Passenger Occupant Detection System Control Module -J706-
Passenger Occupant Detection System Control Module -J706-
- Country specific NAR
  CAUTION:
  Never disconnect the connector between the Front Passenger Occupant Detection Sensor -G128- and the Passenger Occupant Detection System Control Module -J706-.
- Clipped in the storage compartment.