Exhaust Door Control Unit -J883-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following.
-- Install the exhaust door control unit -1- at the same time pay attention to the correct seating of the C-brackets -2-.
NOTE:
install the exhaust door control unit connector first after correct assembly, to prevent movement of the positioner when loose.
After installing the exhaust door control unit the basic setting must be performed. Refer to Vehicle Diagnostic Tester.
-- Under OBD-capable system , Engine electronics J623 perform the Adapt the exhaust Door Control Units -J883 / -J945 function.