Flywheel, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
- The transmission is removed. Refer to TRANSMISSION, REMOVING .
CAUTION:
Risk of Destroying the Flywheel Due to Improper Handling.
- Never remove the bolts with an air or impact wrench.
- When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.
-- Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.
-- Place the :3067 into the hole on the cylinder block -B-.
-- Loosen and remove the bolts for the flywheel.