Drive Plate, Removing And Installing: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Flywheel Lock Adapter :VW558 , Preparing:

Fig 1: Identifying Flywheel Lock Adapter -VW 558- And Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the M8x40 bolt with the M8 nut on the Flywheel Lock Adapter :VW558 .

Removing

Fig 2: Identifying Flywheel Lock Adapter -VW 558- Installed To Cylinder Block And Drive Plate

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Flywheel Lock Adapter :VW558 in the cylinder block and in the hole -A- on the drive plate.

-- Remove the bolts and remove the drive plate.