Exhaust Gas Temperature Sensor, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Bring the exhaust gas temperature sensor before the particulate filter into its installation position:
- Exhaust Gas Temperature Sensor 3 Bank 2 -G497- angle -α- = 40° ± 5°.
- Exhaust Gas Temperature Sensor 3 -G495- angle -β- = 25° ± 5°.
-- Bring the exhaust gas temperature sensor after the particulate filter into its installation position:
- Angle -α- = maximum 15°.