Crankshaft Needle Bearing, Replacing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Bearing Press Piece

Courtesy of AUDI OF AMERICA, LLC

-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.

-- Drive the needle bearing into the crankshaft up to the installation depth using the :VW207C .

Installation depth dimension -a- = 1.5 mm

Fig 2: Identifying Installation Depth
Courtesy of AUDI OF AMERICA, LLC

If the needle bearing was unintentionally driven in too deeply, it must be replaced, because it will be damaged when it is removed again.