Radiator, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• If there are small impressions on the slats. Refer to the appropriate service information .
• The radiator mount is reused with the separated catches. It is attached to the lock carrier. Refer to Parts Information for the correct bolts.
• Replace the O-rings after removing them.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
• Used coolant cannot be used again.

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Fill the refrigerant circuit. Refer to REFRIGERANT CIRCUIT, CHARGING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .